Google+

HUSKYLOCK™ Strap and Belt Loop Foot

Item #: 620097196

With the Strap and Belt Loop foot, create straps and belt loops easily using a cover stitch. Just put a strip into the foot and the strip is folded automatically and stitched in place.

Other information

1. Set the machine for a Coverstitch wide.
2. Use the default stitch settings. Adjust if needed.
3. Cut a strip of fabric, 1” (25mm) wide.
4. Cut the top corner of the strip at a 45 degree angle to form a point.
5. Insert the cut angle into the guide, right side of the fabric facing up. Pull the strip through
the slot and under the foot. Extend the tail of the strip behind the foot. Use
a tweezers to feed the strip into the foot if needed.
6. Snap the Strap and Belt Loop foot onto the machine.
7. Slide the strip approximately 2” (5cm) behind the foot.
8. Lower the presser foot. Be sure both raw edges of strip are turned under before stitching.
Sew the fi rst few stitches. Stop and clip the needle threads close to the presser foot and
continue sewing.
9. For even feeding, hold the fabric strip slightly below the first guide in the front of the foot.
10. Sew at medium speed. Check the fabric as you sew to ensure proper feeding.
Note: Sew the folded fabric strip without additional fabric underneath to create straps
and belt loops or sew the folded strip onto another fabric for decorative effects.
 

image description

Make magic, easier.

Browse our complete accessory catalogue to find just the right prop.

Browse